Cracking open the iPhone 3G

[contentblock id=2]

This never happens but…   I made the mistake of carrying too many things at once, my iPhone being one of them.  I dropped it…   on the tile.  It hurts to remember.

I picked up my phone to find that it was prompting me to insert a sim card.

The annoying no-sim popup.

NO!!! After over 2 years of such careful handling, had I really turned my iPhone into an iPod touch?

I removed the sim card and reinserted it.  Still no luck.  Then it crossed my mind that the top of the phone is where it hit the floor.  Perhaps something was bumped north inside of it.  So I shook it a bit.  Believe it or not it actually worked!  The sim card registered and all was good.  Or so I thought.  Over the next day the sim card warning was on and off.  I didn’t recieve my text messages even when it appeared to have a signal.

I decided I would have to open it up and see if there was anything obviously wrong.  Here’s how it went…

Got the tools. Yah, that's a toy Spiderman suction cup.  Lucky for me, my son is a Spiderman fanatic.
These are the only screws on the body of the iPhone 3G.
I used the suction cup to gently pull the face off the phone. Notice how my thumb was slightly over the edge of the glass to prevent it from popping off quickly.
I gently popped it open. I pulled it open very slowly to discover where the wires exist.
The ribbon wires are at the top of the phone so you want to open it from the bottom.
I had to open the phone all the way to discover how to disconnect the ribbon wires. Apple electronics are always a little different than the rest.
There were 3 ribbon wires. The first 2 unsnapped from the circuit board.
The third ribbon requires you to flip this latch up before it will slide out.
I used the paperclip to pop out the sim card so I could check the connections.
The sim card slides out revealing the 3 sim connection points.
I made sure that the 3 sim connectors were sticking up off the circuit board high enough to make contact with the sim card.

I was amazed by how much finely dusted pocket lint was trapped inside the phone!

I didn’t find anything obviously wrong so I cleaned it out and put it back together.  Yay!  It works!  I’m guessing that one of the “snap-on” connectors was knocked loose from the impact.

One thing about Apple products…   you will always need a tiny screw driver and you’ve got to be really gentle.  When I opened my old school apple mouse to clean it out, tiny parts went flying.  As long as you move slowly and carefully you can see how it’s assembled.  I encourage you to not be afraid of opening up your electronics! It may save you some cash every now and then.  This project really only took me about 30 minutes.

Read previous post:
Outstanding Achievement in Web Development Award For Work On BannerHealth.com

Wow! We just keep doing it this year! We won another award for the BannerHealth.com redesign, this time for web...

Close